HeatShield Is a Great Option for Relining Your Chimney


Do you live in an older home with a masonry chimney? If so, it probably has a clay tile flue liner. Clay tiles have been used to line chimney flues since the beginning of the 20th century, and there are excellent reasons why. These tiles can withstand extremely high temperatures, and they hold up well against the corrosive byproducts of combustion that pass through the flue on their way out of the chimney. Once installed, clay liners will stay in good shape up to 50 years. However, when the clay tiles become cracked and chipped over time, it can be costly to repair them or to replace the liner as it is a very difficult and time-consuming task. When the HeatShield Chimney Repair and Resurfacing System was developed around 20 years ago in Europe, repairing and relining a clay tile liner became so much easier and less costly. At Weststar Chimney Sweeps, our technicians are experienced with using HeatShield, and our customers who have had their clay flue liners repaired or replaced with this product have all been very satisfied. We would like to tell you more about HeatShield and what it can do for your clay tile-lined chimney.

HeatShield Chimney Relining - San Diego CA

What exactly is HeatShield?

Made from a specially formulated “Cerfractory” sealant material, HeatShield can restore the integrity of your chimney’s flue to vent out toxic gases from your home. Eliminating the dangers in your flue caused by cracks, gaps, and spalling, HeatShield will make your chimney as safe and as efficient as it originally was when first built. Depending on the condition of your clay tile liner, the Joint Repair system or the Resurfacing System will be used.

What does the Joint Repair system do?

If our chimney inspectors at Weststar Chimney Sweeps only find mortar joints in your clay tile liner that are deficient, we will use the Joint Repair system. First we will make a custom-made foam applicator blade to fit your chimney. Once this tool has been inserted into your chimney and positioned below each gap or void, we will then add the HeatShield Cerfractory Flue Sealant mixture. Each void and gap will be filled, and when we pull out the foam applicator blade, it will smooth the filled gaps and voids as it comes out of your chimney. Then we scan the repair with a special video camera to be sure the repairs have been done correctly.

What does the Resurfacing System do?

If your chimney liner has a flue that is spalled, but is also structurally still sound, we will use the Resurfacing System. We will pull a custom-fit foam applicator from the bottom of the flue up through top by way of a wench attached to the top of the chimney. We then prime and clean your old liner with a “tie coat” material, which is applied to the flue walls by pulling the plug upwards with the winch. After this coat dries, we then apply the HeatShield mixture with the foam plug in the same way we applied the primer. This method is called “slip casting” or “slip cast extrusion.” After this is applied, we will look at the scanned video to be sure your entire chimney is sealed and smoke-tight.

Have more questions about HeatShield? Contact Weststar Chimney Sweeps to talk to our staff to see if HeatShield is right for your clay tile chimney liner.